|
Product Details:
|
| Product Name: | High Flow Filter Cartridge | Length: | 70"(1778mm), 60"(1524mm) |
|---|---|---|---|
| Material: | PP, Polyester | Filtration Rating: | 1um, 2um, 4um, 5um, 10um |
| Flow Rate: | 3.5m³/h/70" | Max. Operating Temperature: | 80℃, 120℃ |
| OD: | 65mm, 69mm, 70mm | Micron: | 1um, 5um(operating Filter), 10um(start-up Filter) |
| Filter Area: | 6.5m² | ||
| Highlight: | Polyester High Flow Filter Cartridge,4.5 Micron Filter Cartridge,PP High Flow Filter Cartridge |
||
Product Description
High Flow Filter Cartridge contain no surfactants or binders that can break down, leach out, or permit the typical problems of channeling and media migration. Maximum effective open surface areas allow for high flow rates at reduced pressure drop, as well as high dirt holding capacity, long service life, large throughputs, and lower operating costs. These pleated cartridge filters may be used as either pre-filters or as final filters for bulk and point-of-use filtration. They are most appropriate for use when high efficiency filtration and economy are crucial.
Specification:
Pleated depth filtration with maximum filtration area.
High flow rate and good dirt-retention capacity.
Good chemical compatibility for various liquid filtration.
A wide range of fine filters for different industries.
Features and Benefits:
Complete PP structure.
Wide chemical application.
Available for repeatedly backwashing.
Available for outer resin coating before using.
Effectively remove solids.
Long length 70 inch (1778mm) is applied to big flow and high pollution conditions.
Easy install without changing housing.
Replacing Pall Cartridges.
Performance Specifications:
| Product Name | 4.5 /5/20/40 Micron Replacement High Flow PP/Polyester Water Filter Cartridge | |
|
Material |
Filter Medium |
Polypropylene |
|
Center Core |
Reinforced Polypropylene |
|
|
Dimensions |
Outside Diameter |
65mm, 69mm, 70mm |
|
Length |
70"; Customized on request |
|
|
Connection thread size |
1 1/2"-12, M33x1.5; (Customized on request) |
|
|
Screw size |
M6, M8, M10, 3/8; (Customized on request) |
|
| Application |
|
|
Filter Performance
|
Micron |
1um, 5um(operating filter), 10um(start-up filter) |
|
Filter area |
6.5m² |
|
Max. Operating Temperature |
85℃ |
|
Max. Operating Differential Pressure |
2.8bar, 65℃c |
|
Design Flow Rate |
3.9m³/h～4.5m³h |
Product Show
Product Application
Contact Person: Lucy
Tel: 86-21-57718597
Fax: 86-021-57711314
